Updating firmware on magic jack
(This will only reboot the management interface of the NMC2 and not reboot your device/load.) The NMC2 status LED, located on the RJ-45 Ethernet jack, will begin to blink amber during this procedure and rotate through a few color flashing patterns while transferring the different files. Once you do that, ensure the selected protocol is XMODEM and then press Send to begin the file transfer.If you have an AP9631 or AP9635 removable NMC2 UPS Smart Slot card, you can also remove and re-insert the card into the UPS Smart Slot, effectively rebooting the NMC2 and beginning the USB upgrade process this way. Wait for two to five minutes for the upgrade to complete. For AP9617/18/19 based devices, the AOS should be transferred first and then the procedure should be repeated for the application file. After the XMODEM file transfer is complete, set the baud rate back to 2400 within the terminal program's settings. Select a serial port at the local computer and disable any service that uses the port. Connect the provided serial configuration cable (APC part number 940-0299) to the selected 2.5mm Tip-Ring-Sleeve Console port on the Management Card itself. Run a terminal program such as Hyper Terminal, and configure the selected port for 57600 bps, 8 data bits, no parity, 1 stop bit, and no flow control. Also, once you have entered Boot Monitor mode correctly, the Network Management Card's status LED will flicker amber in color.
Considering the type of Internet they have over there.
Go to the XMODEM or Manual sections below for additional instructions. Select TFTP, FTP, or XMODEM from the menu and follow the onscreen instructions. Configure the terminal session to 2400bps, no parity, 8 data bits, 1 stop bit, and no flow control. If there is no included bootmonitor file, upgrade the AOS binary first. To install the application module, repeat step 5 and step 6. If the Management Card is installed in an Expansion Chassis or Triple Expansion Chassis, connect the provided configuration cable (APC part number 940-0299) to the serial port at the Management Card, or connect an RS-232 configuration cable (APC part number 940-0024) to the DB-9 serial port at the expansion chassis. Identify and locate the firmware modules described in the preceding instructions for FTP. Use an SCP command line to transfer the AOS firmware module to the Management Card.
, which are not typically recommended, you will need to choose a new method. Unfortunately, loading applications for different devices may also have encounter this block if AOS versions are not the same. ***For AP9617/18/19 cards that have AOS 1.2.0 firmware and below, you will need to first upgrade to AOS 2.0.2 before upgrading to the latest firmware. If you are using Hyper Terminal, select Call- key several times. If you do not see the prompt, make sure that you have the proper cable and that the communication settings are correct. Enter the Administrator account User Name and Password. If you have changed the Administrator User Name and Password, use the new settings to log in. If you connect an RS-232 configuration cable (APC part number 940-0024) to the DB-9 serial port of the expansion chassis, select 115200 bps. The following example uses xxx to represent the version number of the AOS module: *To upgrade multiple Management Cards using an FTP client or using SCP, write a script which automatically performs the procedure.
In contrary another relative from USA could not use it and decided to return the device within 30 days.
Cause Users may wish to upgrade their firmware to take advantage of enhancements, bug fixes, or new features.